Underwater optical wireless communication, which is useful for oceanography, environmental monitoring, and underwater surveillance, suffers the limit of the absorption attenuation and Mie–Rayleigh scattering of the lights. Here, Bessel-like beams generated by a fiber microaxicon is utilized for underwater wireless propagation. Underwater, the cone angle for generating Bessel-like beams starts from 46°, which is smaller than that in air for Bessel-like beams. When the cone angle of the fiber microaxicons is about 140°, the depth of focus underwater, which is four times as long as the depth of focus in air, has enlarged about 28 µm, 36.12 µm, and 50.7 µm for 470 nm, 520 nm, and 632 nm visible lights. The transmission distance of the Bessel beams for visible lights has been simulated by using Henyey–Greenstein–Rayleigh phase function methods and spectral absorption by bio-optical model due to Monte Carlo methods. The results show that the propagation distance could reach 4000 m, which overcome the limit of the Mie–Rayleigh scattering and absorption attenuation underwater.

Flexible light-emitting diodes (LEDs) are highly desired for wearable devices, flexible displays, robotics, biomedicine, etc. Traditionally, the transfer process of an ultrathin wafer of about 10–30 μm to a flexible substrate is utilized. However, the yield is low, and it is not applicable to thick GaN LED chips with a 100 μm sapphire substrate. In this paper, transferable LED chips utilized the mature LED manufacture technique are developed, which possesses the advantage of high yield. The flexible LED array demonstrates good electrical and optical performance.

Broadband and omnidirectional antireflection coating is generally an effective way to improve solar cell efficiency, because the destructive interference between the reflected and incident light can maximize the light transmission into the absorption layer. In this paper, we report the incident quantum efficiency η_in, not incident energy or power, as the evaluation function by the ant colony algorithm optimization method, which is a swarm-based optimization method. Also, SPCTRL2 is proposed to be incorporated for accurate optimization because the solar irradiance on a receiver plane is dependent on position, season, and time. Cities of Quito, Beijing and Moscow are selected for two- and three-layer antireflective coating optimization over λ = [300, 1100] nm and θ = [0°, 90°]. The η_in increases by 0.26%, 1.37% and 4.24% for the above 3 cities, respectively, compared with that calculated by other rigorous optimization algorithms methods, which is further verified by the effect of position and time dependent solar spectrum on the antireflective coating design.